Search results for "thermal [correlation function]"
showing 10 items of 1923 documents
Treatment of Gaseous Effluents Produced During Electrochemically Assisted Soil Remediation Processes
2021
In many cases, electrochemically assisted soil remediation processes, like electrokinetic or electroheating ones, produce gaseous effluents that need to be collected and treated. Adsorption, absorption, and catalytic and thermal oxidation are often used for the treatment of these gaseous effluents. The chapter describes these technologies reporting their main advantages and disadvantages. Eventually, a comparison of the performances of these technologies was carried out.
Fabrication and Characterization of Polymeric Optical Waveguides Using Standard Silicon Processing Technology
2005
We report the fabrication and characterization of a rib polymeric waveguide having a thick layer of oxidized porous silicon as an innovative solution for the lower cladding. The waveguide was fabricated using standard silicon substrates and Si-based technology. The multimodal guiding structure has a polymethylmetacrylate (PMMA) core and the innovative lower cladding was obtained by thermal oxidation of a porous silicon layer. The waveguide does not have the upper cladding. Propagation loss measurements were performed at 1.48 /spl mu/m using the cut-back method. We obtained propagation loss of about 1.7 dB/cm, confirming the possibility to use the porous silicon oxide as the lower cladding l…
Nanostructured Based Electrochemical Sensors.
2019
In this work, we present some results concerning the electrochemical behavior of nanostructured-based electrochemical sensors. In particular, the attention has been focused on Pd and Cu nanowires for detection of hydrogen peroxide and NiO thin film or Ni@NiO core–shell nanowires for detection of mercury ions. Ordered array of Pd and Cu nanowires was obtained through displacement deposition reaction in a commercial polycarbonate membrane acting as a template. The method leads to stable nanostructured electrodes of Pd and Cu with high surface area. For the detection of mercury ions, we have fabricated a Ni/NiO electrochemical sensor, obtained by mild thermal oxidation of Ni-foil. Some results…
Influence of titanium-vanadium alloys on cell morphology: electron microscopy and ESCA studies
2000
Titanium and its alloys provide optimum metallurgical properties for implants. The formation of an oxide layer favours compatibility with the adjacent hard and soft tissues. Research focuses on further optimizing the passive layer, particularly with respect to minimizing metal ion migration into the tissues. The present study concentrates on two alloys (Ti6A14V and Til.5A125V) coated with oxide layers generated by different techniques: thermal oxidation, anodic oxidation and sol-gel treatment. Only thermal oxidation fails to reduce surface and subsurface concentrations of vanadium, whereas other treatments avoid the element in the outermost surface areas of the alloys. Additionally, the the…
Phonon properties and photo-thermal oxidation of micromechanically exfoliated antimonene nanosheets
2020
Abstract Two-dimensional (2D) sheets of antimonene have attracted increasing attention due to their unique physical and chemical properties prompting potential for diverse applications. We present a facile method to prepare high-quality antimonene nanosheets (ANSs) by micromechanical exfoliation on SiO2/Si substrate. The temperature- and laser power-dependent Raman studies of exfoliated ANSs are reported and analyzed. It was found that both the out-of-plane A1g and the in-plane Eg modes red-shift linearly with increase in temperature, pointing towards anharmonic vibrations of the lattice. The thermal response of the ANSs on a SiO2/Si surface is also described using numerical simulation of t…
Investigation of thermal stability of ethylene copolymers with POSS - Study under static and dynamic conditions
2018
Abstract In the paper there was studied thermal stability of a series of ethylene copolymers with monoalkenylsiloxy- or monoalkenylsilsesquioxanes (POSS) under dynamic and static conditions. The copolymers proved to be more thermally stable than neat polyethylene and neat silsesquioxane comonomers. The kind and the content of the POSS units significantly affected degradation of the copolymers. Thermal oxidation process resulted in structural changes of the (co)polymers as it was evidenced by the variations in the kind and content of carbonyl, as well as by unsaturated end groups. Depending on the structure of the POSS comonomer incorporated into the polymer chain, the silsesquioxane units o…
Oxide growth and tunneling characteristics of Sn-SnO x -Sn junctions
1979
Sn—SnOx—Sn tunneling junctions were prepared by thermal oxidation of vacuum deposited Sn-films. The thickness growth of the oxide was followed by ellipsometric measurements. From logarithmic conductivity measurements the barrier heights were determined. The tunneling characteristic could be well described by the two-band-tunneling model using a value of 0.14 for the ratio of the effective masses in the oxide and the metal.
Size Distribution, Mechanical and Electrical Properties of CuO Nanowires Grown by Modified Thermal Oxidation Methods
2020
Size distribution, Young&rsquo
Empirical model building based on Weibull distribution to describe the joint effect of pH and temperature on the thermal resistance of Bacillus cereu…
2002
Abstract A mathematical model based on Weibull parameters was built to describe the joint effect of temperature and pH on thermal inactivation of Bacillus cereus spores (strain INRA TZ415). The effect of these factors on Weibull model parameters ( β , 1/ α ) was also studied. Heat inactivation tests were carried out in acidified carrot broth as vegetable substrate, following a full factorial design at four levels for temperature (80, 85, 90 and 95 °C) and pH (6.2, 5.8, 5.2 and 4.7). The Weibull distribution model provided good individual fits for the different combinations of temperature–pH tested, with discrepancy factors, D f , coming close to 25% for most cases. The temperature and pH di…
Experimental Evaluation of a New Thermal Process for Microorganisms Inactivation
2015
A new thermal process for the inactivation of microorganisms in beverages has been studied and is presented in this paper. The treatment, not yet studied in the scientific literature, mainly consists of a thermal shock characterized by temperature increases up to 30°C/s, with final temperatures up to 65°C. This study presents the first experimental results obtained by the application of the new thermal treatment, with different combinations of the process parameters (rate of temperature rise, final temperature and holding time), on separate suspensions of Pseudomonas aeruginosa, Escherichia coli, Staphylococcus aureus, Listeria innocua and Candida albicans. The required rapid temperature in…